Rauma
Heia Tweedcape (Rauma 538)
Heia Tweedcape (Rauma 538)
Couldn't load pickup availability
This is a PDF pattern in NORWEGIAN! SOLD ONLY TOGETHER WITH RAUMA YARN!
Heia Tweedcape is a simple cape with a round yoke and edges in broad rib, finished with a small rolled edge. It is knitted with two different yarns held together, which gives lots of room for exciting colour play and a rustic tweed effect. The cape is knitted in the round from the top down – first the neck edge in rib, then the yoke in stockinette with increases, and finally the same rib edge at the bottom.
The Heia series is a collection of patterns designed for the brand-new knitter. No abbreviations are used, all techniques are described in extra detail, and you get good knitting tips along the way.
Yarn: Rauma Fivel + Rauma Alpakka Lin, one strand of each held together
Recommended needles: Circular needle 6 mm (80 and 40 cm) and 5 mm (40 cm)
Gauge: 14 sts in stockinette = 10 cm on the larger needle
Sizes: S/M (L/XL) 2XL/3XL
Yarn required:
Fivel – 200g (250g) 300g
Alpakka Lin – 150g (150g) 200g
Finished measurements:
Bottom circumference: 137 (154) 171 cm
Total length: 46 (50) 54 cm
A roomy cape designed to fit over the whole upper body, ideally with a jacket underneath.
Colour suggestions:
Alt 1 – Fivel Dark grey heather 214 + Alpakka Lin Tweed dark brown 21798
Alt 2 – Fivel Light beige heather 4078 + Alpakka Lin Tweed light beige 1466
The pattern is sent as a PDF by email, so please make sure you enter your email address correctly at checkout.
Usage Instructions
Usage Instructions
• The lamp has a memory function of light brightness and hue - the last used will be default when turning on the light.
• Press the power key to turn on/off the light.
• Press and hold the power to lower the brightness. Press and hold again to increase the brightness. The lamps brightness modes are 15% and 100%.
• When the light is turned on - press ☼ to change the temperature modes between warm, neutral and cold. Long press to enter the SOS flashing mode.
• The neck lamp has a travel lock on/off function.
To enable: When the light is off, long press the power key for 3 seconds and the light will flash twice, the system enters the travel lock-anti touch mode. In anti-touch mode, press and hold the power button for 3 seconds to unlock and turn on the light.
